Anyone use SU to pick the first breaks and to review Stacking Velocity? Can it be done in SU? I usually get data sorted then migrate into a 3rd party software to determine stacking velocity. Anyone doing this is SU? ________________________________ From: Seisunix &lt;seisunix-bounces(a)mailman.seismic-unix.org&gt; on behalf of Dominique ROUSSET &lt;dominique.rousset(a)univ-pau.fr&gt; Sent: Tuesday, August 25, 2020 2:50 AM To: seisunix(a)mailman.seismic-unix.org &lt;seisunix(a)mailman.seismic-unix.org&gt; Subject: Re: [Seisunix] Zero Offset VSP help Hi, just a few suggestions : - check the output data for each step to find where it fails. - print the FK amplitude spectrum to check your filter parameters (why do you use 3 parameters for the filter ? slopes=-something,+something amps=0,1 should be ok to keep positive slopes. Before and after FK filtering. - use suxwigb key=gelev (or the parameter describing geophone depth) to produce well labeled plots of the seismic data in T-Z domain instead of suximage - I prefer to pick the first breaks before FK (or zero phase F) filtering Hope it helps D. Le 25/08/2020 à 01:35, Erdi Apatay a écrit : Hello All I have a script I am using for Zero Offset VSP processing. First of all, my first three traces looked cut so I rejected them. After getting rejected file, I filtered out the downgoing wavefield by sudipfilt. Then, I picked arrivals on the zero amplitude line corresponding to picking amplitudes. Then, I converted those arrival times (seconds) to milliseconds and saving them in a txt.file. After that, txt file is converted from ascii to binary format. Finally, I am adding those time values to the traces by sustatic command. At this point, however, when I try to plot the flattened upgoings, the script plots just a so narrow part as follows: [fkfiltflat.PNG] Can you help me with this issue? I tried to change a lot of things but I could not get whole flattened upgoings. If you would like to check my script, I added here. Thank you Erdi _______________________________________________ Seisunix mailing list Seisunix@mailman.seismic-unix.org<mailto:Seisunix@mailman.seismic-unix.org> https://mailman.seismic-unix.org/listinfo/seisunix -- |Dominique Rousset LFCR UMR5150 / E2S UPPA / Dpt des géosciences| |Univ. Pau et des Pays de l'Adour BP 1155 F-64013 Pau Cedex - France| |mailto:dominique.rousset@univ-pau.fr jami:drousset http://lfc.univ-pau.fr| |Off: +33 559 407 423|Cell: +33 660 861 391|xmpp: dominique@rousset.nom.fr|<mailto:dominique@rousset.nom.fr|>