9 Aug
2020
9 Aug
'20
3:33 p.m.
Erdi,
It looks like you have a zero phase wavelet in your signals. The place
to pick first arrivals is the black maximum. Your arrow is on a side
lobe. Zero phase wavelets can be the result of correlation, like with a
Vibroseis source. Also, they can be a wavelet of choice in some
programs that compute synthetic data. If your data are synthetic, look
into using a minimum phase wavelet, if it is available.
Paul
Dr. Paul Michaels, PE
Professor Emeritus, Engineering Geophysics
http://173.255.241.228
https://www.boisestate.edu/earth/people/paul-michaels/
On 8/5/20 1:21 PM, Erdi Apatay wrote:
Hello Everyone
I said before that I was trying to do Zero Offset VSP Processing. To
do that, I tried to use free software is called MVSP and Crewes
toolbox. My problem is that I can start picking first break arrivals
from 4th trace, and I can not see and pick the first three traces when
I look at the data during the picking.
The first software itself assigns negative values for the first three
traces, which results in negative velocities. On the Crewes, I am
trying to assign values like 0.001 0.002 0.003 before the 4th trace
because the 4th trace's time is 0.006, which probably gives rise to
wrong velocities.
In short, Can I do anything about this issue on Seismic Unix? Is there
any chance to fix it?
I added one of my files and the screenshot zoomed where the problem
is. I modeled and created this data on different code (fdelmodc).
**The data is passive data, and I utilized the noises, recording 120s.
So, when you look at my data, you need to zoom in to see closely.
Thank you
Best regards
Erdi
_______________________________________________
Seisunix mailing list
Seisunix(a)mailman.seismic-unix.org
https://mailman.seismic-unix.org/listinfo/seisunix